Cehisa EP 12 Edgebanding Machine
(No Corner Rounding)

A glue pot machine, which applies hot melt glue directly to the edge of the panel allowing the application of unglued coil material, high pressure laminates and solid wood lippings.

With a lipping capacity of up to 6mm and a feed speed of 10m/min this machine is ideally suited for a general manufacturer who needs to apply solid timber lippings.

Working Units

Equipped with a pre-cutting guillotine
Strip feed magazine
Double jump milling station
Front and rear end trim station
Top and bottom trim station
Scraper unit
Buffing unit

Technical Data

Minimum and maximum length of panel: 120 mm – Unlimited

Minimum and maximum width of panel: 110(75) mm - Unlimited

Minimum and maximum thickness of panel: 8 mm  - 45(40) mm

Minimum and maximum thickness of edging: 0.4 mm - 6 mm

Feed speed: 10 m/min

Power requirement: 415 V - 3 Phase – 20 amp isolator

Compressed air: 6 - 7 Bar – 2 cfm

Overall Machine Length: 5480 mm

Minimum operating space required (length): 5100 mm + 2 x maximum board length mm

Minimum operating space required (width): 1200 mm + maximum board length mm