EBM KDP 103SLK

This machine is a compact Edge Banding Machine for straight workpieces with hot melt application to the workpiece edge.
The trim saw unit, which trims flush the workpiece front and rear edge excess only with one saw blade and the roller cutting unit are controlled electro pneumatically.

The high frequency motors of trim saw and shaper units are supplied with current by a rotating frequency inverter.
The necessary contact pressure for gluing together the edge band material with the workpiece is produced by the inclined table rollers and also by the 2-3° inclined to the workpiece transport direction band feed.

Working Stations:

Front and rear end trim material up to 3mm thick
Top and bottom trimming
Glue Scraping Unit

Technical Data

Minimum and maximum length of panel 260 mm – Unlimited
Minimum and maximum width of panel 90 mm - Unlimited
Minimum and maximum thickness of panel 10 mm - 45 mm
Minimum and maximum thickness of edging 0.4 mm - 3 mm
Feed speed 10 m/min
Power requirement 415 V - 3 Phase – 20 amp isolator
Compressed air 7 Bar – 2 c.f.m
Overall Machine Length 3100 mm
Minimum operating space required(length) 2300 mm + 2 x maximum board length mm
Minimum operating space required(width) 1100 mm + maximum board length mm